Retrotec DM32 Manual de usuario descargar pdf (Pagina 13)

Page 13 of 16

©Retrotec Inc. 2013

a) Enter the value for the [IP address] (default may work for a single PC to gauge connection)

b) Enter the value for the[Gateway] if different from the Default

c) Enter the value for the [Subnet mask] if different from the Default

Figure 16: Wired network with a switch, hub, or direct to PC connection uses Static mode

8. Click "Save to Gauge". If you want the same parameters entered into all gauges, click “Copy to

All Gauges”.

9. Disconnect the gauge from the PC.

Figure 17: User is notified when the gauge is successfully updated with Wired network parameters

The networking parameters are now set into the gauge. Follow the next steps to verify:

1. On the gauge itself, tap [Settings].

2. Tap […] and then tap [Network]

1 2 ... 8 9 10 11 12 13 14 15 16

Sin comentarios

Retrotec DM32 Manual de usuario Pagina 13